Replacing a lightswitch

By Christian · 5 October 2026

If you need to replace a lightswitch that has already been configured to control lights and other functions, you must first save the configuration of the existing lightswitch.

FYI: A simpler method for configuring a new lightswitch to work exactly like the old one is currently being developed.

Follow the instructions below.

Step 1 - Replace the lightswitch

Have an electrician replace the lightswitch. Ask the electrician to write down the ID number of the new lightswitch, or leave the plastic cover off so you can read the ID number yourself and install the cover later.

Step 2 - Note the existing configureation of the lightswitch

  • Open your zensehome app
  • Tap the room where the lightswitch has been replaced and configure the new one
  • On the room page, under the "Switches" heading, select the lightswitch that has been replaced
  • Tap "Maintenance"
  • Tap "Configuration"

We recommend using a peice of paper og similar method to note the configurations shown on this page on the app.
For example, your notes could look like this:

Button 1 - Short Press:
Action - On/Off
Links - Coat Area Light (ID number), Wardrobe Spotlight (ID number)

Button 1 - Long Press:
No configuration

Button 2 - Short Press:
Action - On/Off
Links - Coat Area Light (ID number), Wardrobe Spotlight (ID number)

Button 2 - Long Press:
No configuration

Guide Light:
Guide Light - 0
Activated Light - 0

Step 3 - Change the device ID from the old lightswitch to the new lightswitch

  • On the room page, under the "Switches" heading, select the lightswitch that has been replaced
  • Tap "Maintenance"
  • Tap "Type"
  • Tap "Change Devide ID"
  • Enter the ID number of the new switch, either provided by your electrician or read directly from the lightswitch
  • Tap "Save"

Step 4 - Run Maintenance

After tapping "Save", you will be returned to the selected room page. Select the replaced lightswitch

  • Tap "Maintenance"
  • At the bottom of the screen, tap "Run Maintenance"
  • Wait untill all points show a green check mark

Step 5 - Configure the new lightswitch

  • In the app, open the room(s) containing the devices listed in your notes that were connected the previous lightswitch

  • Open each device one at a time, for example: Coat Area Light (ID number)

  • Tap "Button On/Off Control"

  • Tap "Select buttons"

  • Find the name of the relevant lightswitch

  • Refer to the "Links" listed in your notes

    From example:

    Button 1 - Short Press:
    Coat Area Light (ID number)

    Button 2 - Short Press:
    Coat Area Light (ID number)

  • Select "Button 1 - short press" and "Button 2 - Short press" so that they are marked in white and with a vertical line

  • Tap "Save"

Repeat Step 5 for all devices listed in your notes. In the example above, this would be Coat Area Light (ID number) and Wardrobe Spotlight (ID number).

The new lightswitch should now be configured the same way as the old one.